If you have downloaded the CloseOpens script, it will most likely close the opens automatically. Line segments may not form a closed loop.Run StrayLines to see if any of these types of lines exist in your drawing. There may be stray line fragments that interrupt normal face creation.Try scaling your model up 10X or more and rerun. SketchUp TM will not create very small faces, less than approximately 1/16" or less than 1mm. If, after running Makefaces, you are not satisfied with the results, there may be reasons that all the faces you thought should have been created, did not get created. Another script, ProgressBar, is required.A progress bar will be updated on the Status Bar while running.Makefaces will run, and will report statistics at the end of the run.Select your whole model or a portion of your model.Makefaces.rb loops through your model and creates faces where faces need to be created.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |